Rotary Angle Encoder and Remote Display, with a 6mm Diameter Shaft. Angle Tilt Inclinometer.

DetailsThe remote display has the on/off button and a zero function button allowing the display to be set to zero degrees in any position.The rotary encoder has a flat steel flange with four mounting holes and 6mm diameter shaft.The Display is linked to the rotary encoder by a standard RJ45 cable. This allows the display and encoder to be disconnected. A 900mm cable is includedThe gauge is powered by a standard CR2032 battery located behind a twist lock compartment on the rear of the displayWe would recommend that 5 metres is the maximum cable length when using the Angle Tilt Sensor/Inclinometer.Cables can be extended to 5 metres but please note that this must be a RJ45 Cat 5 lead that is screened. If not not there may be interference issuesPlease Note: The rotary encoder must not be used at high speed/rpm. Protect encoder from coolant and moisture ingressApplications Include: Rotary tables, Dividing heads, Angle table, Telescopes, Tilting angle plates, Milling machine head angle etcRange: 0-360 degrees (360 degrees displays as 0.0 degrees and will continue to count up)Accuracy - +/-0.1 degreesWeight(g)220.000000TypeDigital Angle FinderBrandMachine DROMPNME-AN-REM-ROTGTIN5055396108583ConditionnewDisplay TypeDigital  /* March 10, 2023 17:59:20 */!function(){function s(e,r){var a,o={};try{e&&e.split(",").forEach(function(e,t){e&&(a=e.match(/(.*?):(.*)$/))&&1