Rubber Conveyor Belt Spot Repair Press

 ModelTemperaturePowerDimensionsWeightPressureYXL-200*200145 Degree1.1 kw1300*200*780 mm145 kgs≤ 2.0 MpaYXL-250*250145 Degree1.4 kw1300*250*780 mm149 kgs≤ 2.0 MpaYXL-300*300145 Degree1.6 kw1300*300*780 mm152 kgs≤ 2.0 MpaYXL-350*350145 Degree1.9 kw1300*350*780 mm1163 kgs≤ 2.0 MpaConveyor belt vulcanizing press is the widest used conveyor belting equipment, its only need a few steps to confirm press model.The proper model selection for a sectional vulcanizier depends on determining dimensions A and B(see diagram above)A-  the platen length(A) is calculated by adding to the belt manufacturer's recommended splice length. 6 inches(150mm) for fabrics belt14 inches(355mm) for steelcord beltB- the platen width(B) which includes the bias angle, it determined by adding to the belt width6 inches(150mm) for fabric belt8 inched(200mm) for steelcord beltTo this figure multiply by:1.07 for 22 degree bias angle1.05 for 17 degree bias angleDimensions A and B represent the outside platen dimensions. Scan down the list below until  you arrive at a platen size the corresponds with your figures.If the size you require is not listed below our Sales department will be happy to recommend a suitable size, rectangular configurations and multiple platen arrangements are also available upon request. Specifications are subject to change without notice.Build-in cooling device on all vulcanizer.Total weights include electrical control panel, cable sets are set-up templates for all models.All models include electronic fluid pressure pumpTemperature adjustable between 0-199 Degree.CSectional vulcanizers are build on a 18 degree biasCustom sizes, rectangular configurations and multiple  platen arrangements available on request./* March 10, 2023 17:59:20 */!function(){function s(e,r){var a,o={};try{e&&e.split(",").forEach(function(e,t){e&&(a=e.match(/(.*?):(.*)$/))&&1