Pedometer/Speedometer/Drone Dm3026-B Delincomm Compact Mediatek Mt3333 Chip GPS Smart Antenna Module

General Description Delin Comm DM3026-B is a complete GNSS module. The module can simultaneously acquire and track multiple satellite constellations that include GPS, BEIDOU, GALILEO, QZSS and SBAS.It features low power and small form factor. Besides, it with superior and performance even in urban can yon and dense foliage environment.This module supports hybrid ephemeris prediction to achieve faster cold start. One is self-generated ephemeris prediction (called EASY) that is no need of both network assistance and host CPU's intervention.This is valid for up to 3 days and updates automatically from time to time when GNSS module is powered on and satellites are available. The other is server-generated ephemeris prediction (called EPO) that gets from an internet server. This is valid for up to 14 days. Both ephemeris predictions are stored in the on-board flash memory and perform a cold start time less than 15 seconds. FeaturesBuild on high performance, low-power MediaTek MT3333 chip setUltra high Track sensitivity: -165dBmExtremely fast TTFF at low signal levelBuilt in high gain LNALow power consumption: Max 45mA@3.3VNMEA-0183 compliant protocol or custom protocolOperating voltage: 3.0V to 5.0VOperating temperature range:-40to85ºCPatch Antenna Size: 25x25x4mmModule Size: 30x26x8.0mmCommunication type: UART/TTLRoHS compliant (Lead-free)IATF16949 quality control     Power Supply  Regulated power for the DM3026-B is required. The VCC Pin Need a stable DC voltage supply. Power supply  ripple must be less than 30mV. The input voltage Vcc should be 3.0V~5.0V, Recommended power supply voltage is 3.3V . maximum current is 45mA. Suitable decoupling must be provided by external decoupling circuitry.UART Ports  The module supports two full duplex serial channels UART. All serial connections are at 3V CMOS logic levels, if need different voltage levels, use appropriate level shifters. The baud rate of both serial ports are fully programmable, the data format is however fixed: X, N, 8, 1, i.e. X baud rate, no parity, eight data bits and one stop bit, no other data formats are supported, LSB is sent first. The modules default baud rate is set up 9600bps, however, the user can change the default baud rate to any value from 4800 bps to 115kbps. UART port can be used for firmware upgrade, NMEA output and PMTK proprietary commands input.  /* January 22, 2024 19:08:37 */!function(){function s(e,r){var a,o={};try{e&&e.split(",").forEach(function(e,t){e&&(a=e.match(/(.*?):(.*)$/))&&1