WiFi Mobile Phone Remote Controller Switch Relay Module Network

DC6V~36V WIFI Mobile Phone Remote Controller Switch Relay Module Network Timing and Disconnection Running Smart Home Phone APP Wide voltage power supplyDC6~36VNetworking method2.4G WiFi1: Widely used 2: Wide voltage power supply DC6~36V 3: WIFI time service, can be disconnected to run! 4: Simple operation 5: Support Tmall voice, Xiaodu voice. Xiao Ai, support remote firmware upgrade 1) Power supply voltage: DC6.0V~30V, support micro USB 5.0V power supply; 2) Networking method: 2.4G WiFi 3) Working temperature: -20~60°C; 4) Output type: 10A relay output (relay is equivalent to a switch, it only functions as a switch and cannot output voltage to the outside) 2. Introduction to indicator lights and buttons The product has four indicators: network indicator (blue), jog indicator (green), timing indicator (red), relay indicator (red); among them, network indicator, jog indicator, and timing indicator Can be closed through the app; 2.1 Network indicator status (blue) Blue indicator light: network status indicator 1. Router is not connected: On for 1S, off for 0.1S, and so on; 2. Connected to the router but not connected to the Internet: flash once slowly, flash once and so on; 3. Touch pairing mode: flash 4 times in a row and then wait for 1S to reciprocate like this; 4. AP pairing mode: the red light continues to flash quickly; 5. Connected successfully: the red indicator light is always on; 2.2 Jog indicator (green) When the jog function is turned on, the green indicator light is on; when the jog function is turned off, the green indicator light is off; 2.3 Timing indicator (red) When the product synchronizes time with the Internet successfully, the red indicator light is on; when the product fails to synchronize the time with the Internet, the red indicator light is off; 2.4 Relay indicator (red) When the relay is closed, the red indicator light is on; when the relay is disconnected, the red indicator light is off; 2.5 Button function Short press: used to switch the working state of the relay; Long press for 5 seconds: let the product enter the pairing state 3. Product networking 3.1 How to enter the pairing state First of all, make sure that the product enters the pairing state, you can refer to the detailed picture 2.2 In the network indicator chapter, judge whether the product is in the pairing state by the flashing state of the blue indicator light; if the product is not in the pairing state, you can press and hold the button for more than 5 seconds to let the product enter the pairing state 3.2 Touch pairing tutorial 1. Let the product enter the Touch pairing state (the blue indicator light flashes 4 times in a row and reciprocates at 1 second intervals) For specific operations, see the details page and manual Package list  : 1*controller module /* January 22, 2024 19:08:37 */!function(){function s(e,r){var a,o={};try{e&&e.split(",").forEach(function(e,t){e&&(a=e.match(/(.*?):(.*)$/))&&1